Skip to content
NewsNew: Door and Entry Door design screens are complete
Back to the blog

Wardrobe interior dimensions: the right heights for hanging, shelves and drawers

Updated: Measuring7 min readBy

Measuring a wall in a room with a tape measure

Summarize this article with an AI tool:

Short answer

The interior depth of a wardrobe for hanging is commonly 55–60 cm. Leave 150–160 cm of clear height for long dresses and coats, and 95–110 cm for jackets and shirts. 30–40 cm between shelves and 12–25 cm of inner height in drawers covers most needs. Always think of the sizes as clear interior dimensions.

Why should wardrobe sizes be right from the start?

A wardrobe is one of the most used pieces of furniture in a home, and when its sizes are wrong the problem repeats every day. If the hanging rail is a little low, long dresses touch the floor; if the shelves are spaced too far apart, folded clothes topple over; if the drawer height is chosen wrong, sweaters do not fit or half the drawer stays empty.

In this article we have gathered the size ranges commonly used in workshops, section by section. The values are not hard rules but a starting point; the customer's height, the ceiling height and the room the wardrobe will be used in change the sizes.

How deep should a wardrobe be?

The shoulder width of a clothes hanger is about 45–50 cm. The interior depth of the carcass should be more than this so clothes are not squashed when the door closes.

Door type Common carcass depth Note
Hinged door 58–60 cm The door closes in front of the carcass
Sliding door 62–65 cm Extra allowance for the track and two door thicknesses
No door / walk-in closet 50–60 cm Hangers are visible from outside

If the depth has to be reduced (narrow corridor, small room), a pull-out hanging rail can be used instead of a standard rail. With this fitting, hanging is possible even at 35–40 cm depth, though capacity goes down.

Height of hanging sections

The hanging section takes up the most space in a wardrobe and its size is the most debated. Two types of hanging section are commonly used:

  • Long hanging: 150–160 cm of clear height for dresses, coats, overcoats and suit trousers. For very long dresses this can go up to 170 cm.
  • Short hanging: 95–110 cm for shirts, jackets, blouses and skirts. In a tall wardrobe two short hanging sections can be set one above the other; that means double the hanging capacity in the same width.

The position of the hanging rail is also part of the size. The rail is fitted about 5–7 cm below the shelf above it, so the hanger hook goes in and out easily. If the upper short hanging section will be hard to reach, a pull-down wardrobe lift mechanism can be considered.

How long can a hanging rail be?

A hanging rail carries load. In a full hanging section, if the rail span exceeds 90–100 cm, the rail can sag in the middle. In wider sections, a middle upright or a center support bracket is used.

Shelf spacing and shelf width

For folded clothes, a gap of 30–40 cm between shelves is enough. On taller shelves, piles of clothes topple over and it becomes hard to take out the item at the bottom. For shoe shelves 15–20 cm, and for bag and box shelves 30–35 cm, is the common range.

Shelf width also matters. On an 18 mm melamine chipboard shelf, when the span exceeds 80–90 cm, sagging appears over time once books or thick blankets are placed on it. In that case:

  • You can split the span by adding an upright.
  • You can cut the shelf from 25 mm or double-layer material.
  • You can add a banded front rail (front batten) to the shelf to increase stiffness.

If adjustable shelves will be used, shelf pin holes are drilled in the side uprights at 32 mm spacing. This size matches the widespread “32 mm system” and uses the same grid as hardware such as hinges and runners.

Drawer sizes

Drawer inner height is chosen for what it will hold:

Use Inner height
Underwear, socks, accessories 10–15 cm
T-shirts, folded shirts 15–20 cm
Sweaters, tracksuits 20–25 cm
Blankets, seasonal clothes 30 cm and up

Drawer depth is found by subtracting the runner and back panel allowance from the carcass depth. In wardrobes with doors, if the drawer sits behind the door, the drawer front must not hit the hinges or the door overlay. That is why the fronts of internal drawers are usually set back a few centimeters from the door. For runner clearance and box sizes, see our drawer slide selection article.

Top cabinet section

In wardrobes that run to the ceiling, the top section is used for seasonal items, suitcases and duvets. Keeping this section 40–60 cm high makes access easier. If the ceiling is high, drawing the top section as a separate carcass also makes delivery and installation easier; a single 2.5-meter carcass may not go up a narrow staircase.

What to watch for when measuring for a wardrobe

  1. Are the ceiling and floor level? In older buildings the ceiling can vary by a few centimeters from one end to the other. Work from the lowest point.
  2. Skirting and sockets. If the wardrobe will sit tight against the wall, the positions of the skirting and sockets should be marked on the measurements.
  3. Door swing area. Hinged doors must not hit the bed, the room door or a window.
  4. Cornice and beams. If there is a projection on the ceiling, the top carcass is notched or made as a separate section.
  5. Installation allowance. In wardrobes that run to the ceiling, 2–3 cm is left so the carcass can be tilted upright; the gap is closed later with a filler.

Our furniture measurement and part takeoff article gives a step-by-step guide to taking measurements.

What to watch for in the drawing

Think of the sizes as clear interior dimensions: the height left after deducting the carcass thickness, shelf thickness and top/bottom panels is the space the hanging section really uses. In a 220 cm high carcass, once the bottom and top panels, plinth and a middle shelf are deducted, the space left for long hanging is less than you might think.

Drawing the wardrobe module by module and defining the interior divisions separately makes sure all the parts update correctly when the customer changes a size. When the cut list comes from the drawing, shelf, upright, drawer and door parts are not recalculated by hand. In moducut, wardrobe modules come ready in the library; see the Drawing page for details.

Frequently asked questions

What is the standard wardrobe height in cm?

In ready-made wardrobes 200–220 cm is common. In made-to-measure wardrobes the height usually goes up to the ceiling and the top section is made as a separate carcass.

How wide can a wardrobe door be?

For hinged doors, 50–60 cm is the common upper limit; a wider door puts too much load on the hinges and sags over time. On long doors, three or four hinges are used depending on the door height.

Do the sizes change for a children's wardrobe?

Yes. The hanging rail is set at a height the child can reach (about 100–120 cm), and adjustable uprights are used so it can be raised as the child grows.

Share

You may also like

Cookie settings

Choose which cookies you allow. You can change your choice any time from the “Cookie settings” link at the bottom of the page.