Where do I set the passes for inner cuts?
Production and CNC · Last updated:
Short answer
From INNER CUT, under the Sizing section of Settings › “CNC Settings” › Cutting Settings. Choose With contour (two passes) or Without contour (single pass) for the Pass; with contour, enter the first and last pass in mm.
Step by step
- In the editor, open Settings › “CNC Settings” and go to Cutting Settings.
- Find the INNER CUT heading under the Sizing section.
- On the Pass row, choose With contour (two passes) or Without contour (single pass).
- With contour, type the “First pass (18 mm)” and “Last pass” values; the two are linked.
- The same setting also appears in Nesting Settings and the Cutting simulation; changing it in one changes the others.
With a contoured inner cut, the middle piece stays attached to the sheet until the last pass; the last pass runs at the end of the program, after the door is cut to size.
Related questions
Was this answer helpful?
