How do I add a gola handle?
Drawing and modules · Last updated:
Short answer
Double-click the module to enter design mode and click a door. In the Gola Handle section of Part Properties, choose “Gola on top (J)” or “Gola between (C)” and press “Apply”; the gola is applied to the whole carcass.
Step by step
- Double-click the module in the room, or right-click it and choose “Edit”; the module opens in design mode.
- Click one of the module’s doors; the Part Properties panel opens.
- In the Gola Handle section, choose the “Gola on top (J)” card (above the door) or the “Gola between (C)” card (between two doors); both can be selected together.
- If you do not want a gola channel cut into the side panels, turn off “Cut gola groove in sides” under Carcass.
- Press “Apply”, then leave design mode with Project › “Apply” on the ribbon.
To give several modules a gola at once, open Room Design › “Bulk”, choose the scope, pick “Gola” on the Handle tab and press “Apply”. If both J and C are turned off, the gola is removed.
Related questions
- How do I change a module’s size?
- How do I draw a cabinet with a curved edge?
- How do I get the hardware list?
Was this answer helpful?
